QSC KC12 - Disassembly

13
Disassembly
1. Use one hand to hold the KC-SP32 in place, and another to lift the KC12T top box
loudspeaker out from the coupler receiver. It may be necessary to lightly wiggle.
a. Place the KC12T top box loudspeaker into the provided KC12-TOTE, with the
grille facing towards the center of the tote, and the pole section of the top box
resting against the angled foam spacer. See Figure6.
2. Use one hand to hold the KC12S subwoofer in place, and another to lift the
KC-SP32 column pole out from the coupler receiver.
a. Place the KC-SP32 column pole into the the provided KC12-TOTE, in the
padded compartment area next to the KC12T top box loudspeaker, with the
divider in between the KC12T and KC-SP32. See Figure6.
3. Use the handle on the top of the KC12S subwoofer and the handles on the bottom
of the subwoofer to transport to and from your deployment location.
KC-SP32
KC12T
KC12-TOTE
Angled foam
spacer
—Figure6—
KC12T
KC-SP32
KC12S
—Figure5—