Auto control key: [PLAY/AUTO] ;
Wiper control key: [WIPER/MENU] ;
Light control key: [LIGHT/F1] ;
Auxiliary device control key: [AUX/F2]
Preset Setting
In PTZ control mode, press [REC/SHOT] key, and press the preset number
(three numeric keys), DVR will adjust the corresponding preset number.
Repeat pressing [REC/SHOT] key, and press the preset number, DVR will
adjust that preset number.
When you exit PTZ control mode, the camera will stay at the current
position.
Note: The PTZ preset number is set already. Please refer to PTZ menu for
preset setup. V1.4 firmware can support 128 preset numbers at most.
Start/Stop auto in PTZ control mode
In PTZ control mode, press [PLAY/AUTO] key to start PTZ auto function.
Press [PLAY/AUTO] key again to stop.
When PTZ is in auto mode, if you exit PTZ control mode, PTZ will continue
auto function. You must enter into PTZ control mode again, and press
[PLAY/AUTO] key to stop.
Exit PTZ control mode
Press [ESC] or [ENTER] to exit and return preview mode.
To Next Page
Loading...
General