PPPoE: DVR support PPPoE dial-up function.
Example: Use PPPoE function
Step 1: Enter into “Network” menu.
Step 2: Select NIC type.
Step 3: Input port number. In the port edit box, use numeric keys
to input port number. The port number must be more than 2000.
Step 4: Input DNS IP. Input one fixed Internet IP address where the
IP analyst software (IPServer) is run.
Step 5: Input PPPoE parameters. Use [ENTER] or [EDIT] key to
enable PPPoE function (set PPPoE flag as “√”). Input PPPoE username,
password and verify password that ISP provided.
Step 6: Save parameters. In “Network” menu, press “Confirm” to
save parameters. Reboot DVR to make parameters into effect. In
reboot process, DVR will start dialup using PPPoE function. If DVR
dialup Internet successfully, DVR will display the dynamic internet IP
address in “Network” menu.
5.15 PTZ
There is one RS-485 port at DVR rear panel used for PTZ control. You can
setup RS-485 parameters to match your PTZ protocol. In main menu,
move “Active Frame” to PTZ icon and press [ENTER] key, you can enter
into PTZ menu as following:
To Next Page
Loading...
General