Press “Add” button to add one cruise point.
Press “Confirm” button to save the cruise point into the sequence.
After you finish setup the sequence number, press “StartSeq” to check the
current sequence. Press “StopSeq” button to stop checking.
You can delete cruise points in one sequence.
After you finish sequence setup, press “Return” button back to “PTZ”
menu. In “PTZ” menu, press “Confirm” button to save the modification.
Please make sure the PTZ you are using can support sequence function.
Cruise setup
In “PTZ” menu, press “Setup” button on the right side of “Cruise” item,
you can enter into “Cruise” setup menu:
Press “RecCru” button, you will enter into “PTZ control” interface. You can
start controlling PTZ with direction keys, press [ENTER] to save the
operation track and return “Cruise” setup menu. Press “StartCru” button
to repeat the PTZ track until you press “Stop” button.
Press “Return” button back to “PTZ” menu. In “PTZ” menu, press
“Confirm” button to save this cruise.
Please make sure the PTZ you are using can support cruise function.
To Next Page
Loading...