INSTALL THE HAND FEED TABLE AT THE LEFT OF THE BASE:
t the slots of the Base over the tabs of the table.
CONNECT THE LAN to a network RJ45 plug of the Base and
to the LAN wall socket using the LAN cable
B
.
OPEN THE BASE COVER, remove the headset protecting
strips and insert the headset in its compartment, then push
the headset back until it clicks.
WRITE DOWN THE PSD number, you may need the number
later.
INSTALL THE PSD in the slot and then close the cover.
CONNECT THE SYSTEM POWERPLUG. Follow the installation wizard on the screen. Refer to the installation section in the User Guide.
IS-330/350 QUICK INSTALLATION GUIDE
B
C
CAUTION: use a solid and steady table, far
from any door or fan.
2 4
7
5
3
6
C
A
1
Check the box contents.
For more information about your mailing
system, please visit :
kb.quadient.us
To Next Page
Need help?
General
