Connect the weighing platform connector (e) into the COM PORT
on the back of the machine. Then connect the LAN cable (f) and
power cable (g) to each side of the machine.
7
Open the cover. Place the meter (i) into the meter bay and slide in until
it fi ts securely into position. Close the cover.
3
Machine components:
Machine Base
Feeding Table
Catch Tray
Weighing Platform
LAN Cable
Power Cable
MeterInk
Cartridge
Unpack all components from the box, remove packaging
and any transit tape.
1
Lift machine slightly on the left hand side and align the hooks to attach the feeding
table (b) – attach the catch tray (c) to the right hand side of the machine.
5
Lower weighing platform release panel at the back
of the machine. Place weighing platform (d) on
top of the machine and slide forward to lock. Lift
panel to secure and clip cable into place.
Insert the ink cartridge (h) at an angle into the machine with the ‘TOP’ and
‘LOCK’ stickers facing upwards. Push the ink cartridge (h) towards the back
of the machine until you hear a ‘click’ - close the cover of the machine.
Turn on the machine using the switch behind the
power cable (g) and follow the steps on screen.
8
Select LAN and press to test connection
type.
OK
Installation Process
1 LAN
9
iX-3 Series Base
Quick Installation Guide
For more help with your installation, please visit: kbhelp.quadient.com/ix3_install_en_dl
Lift the cover of the machine to reveal the
ink cartridge (h) and meter (i) bays.
2
6
4
Follow the steps on screen to complete the
procedure
Next
Installation Process
Press the ‘Next’ to start the
Online service
declaration.
11
Mem
Mem
Back of the machine
Weighing Platform
Cable
OK
Installation Process
Enter the registration PIN code
Enter the registration PIN code : 00000
10
00000
Mem
To Next Page
Need help?
General
