Disconnecting your Mailing System
How to Disconnect your Mailing System
Only unplug the power cord when the Mailing System is in Sleep
Mode (Mode to avoid keeping the Ink Cartridge in a position where
the ink may dry out and become unusable).
1. First switch your Mailing System to Sleep Mode (See How to Activate 'Sleep' or 'Awake'
Mode on page 19).
2. Unplug the power cord from the wall outlet.
3. Unplug the LAN cable and the telephone cord from the back of your system as
they may still be powered up.
Telephone and LAN Connections
To prevent damage to your components, do not confuse telephone
jacks that connect to the Modem with LAN connectors.
Network/PC LAN (8 wires)
To ensure the quality of your system connections, follow the recommended precautions
below:
•
Avoid using your system during an electrical storm; as there may be a risk of electrical
shock from lightning.
•
Do not install telephone jacks or LAN connectors in a wet location.
•
Disconnect the telephone or LAN cable from the wall before moving your system.
To reduce the risk of fire, only connect the modem to the telephone
line using supplied cable (see Specifications on page 177 ).
1
Read this First
7
| Page 7 | |
To Next Page
Loading...
Need help?
General
