EasyManua.ls Logo

Quadro 350D - Page 59

Quadro 350D
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
Level ChecksLevel Checks
Level ChecksLevel Checks
Level Checks
n Wait for 5 minutes after switching off the engine.
n Rest the vehicle on its centre stand and on level ground.
n Loosen and remove the filler plug/dipstick
«1»«1»
«1»«1»
«1» and dry it with a clean rug.
n Refit and tighten the filler plug/dipstick
«1»
«1»
«1»«1»
«1» (fig. 02_06).
n Loosen and remove the filler plug/dipstick «1» for a second time
and check that the oil level is now between
««
««
«
MINMIN
MINMIN
MIN
»»
»»
» and
««
««
«
MAXMAX
MAXMAX
MAX
»»
»»
»
marks as show in the figure (03_06)
Running the engine with insufficient or contaminatedRunning the engine with insufficient or contaminated
Running the engine with insufficient or contaminatedRunning the engine with insufficient or contaminated
Running the engine with insufficient or contaminated
oil will cause engine damage. If the low oil pressureoil will cause engine damage. If the low oil pressure
oil will cause engine damage. If the low oil pressureoil will cause engine damage. If the low oil pressure
oil will cause engine damage. If the low oil pressure
indicator remains on, stop the engine immediately.indicator remains on, stop the engine immediately.
indicator remains on, stop the engine immediately.indicator remains on, stop the engine immediately.
indicator remains on, stop the engine immediately.
ATTENTIONATTENTION
ATTENTIONATTENTION
ATTENTION
Fig.03_06Fig.03_06
Fig.03_06Fig.03_06
Fig.03_06
Fig.04_06Fig.04_06
Fig.04_06Fig.04_06
Fig.04_06
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLE
TT
TT
T
op upop up
op upop up
op up
Any oil top up must occur only after level check.
If the oil level is below the
MINMIN
MINMIN
MIN marking, add oil a little at a time
through the filler plug hole until the correct level is reached.
For top ups, proceed as follows:
n Remove the filler plug/dipstick and add oil.
n Check that the oil level is between the
«
«
««
«
MINMIN
MINMIN
MIN
»»
»»
» and
««
««
«
MAXMAX
MAXMAX
MAX
»»
»»
» marks
(see figure 03_06).

Table of Contents

Related product manuals