EasyManua.ls Logo

Quadro 350D - 6.8 BATTERY

Quadro 350D
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
64
Always dispose of old batteries responsibly. For theirAlways dispose of old batteries responsibly. For their
Always dispose of old batteries responsibly. For theirAlways dispose of old batteries responsibly. For their
Always dispose of old batteries responsibly. For their
disposal, please observe their local regulations.disposal, please observe their local regulations.
disposal, please observe their local regulations.disposal, please observe their local regulations.
disposal, please observe their local regulations.
Do not disconnect the battery leads with the engineDo not disconnect the battery leads with the engine
Do not disconnect the battery leads with the engineDo not disconnect the battery leads with the engine
Do not disconnect the battery leads with the engine
running.running.
running.running.
running.
WARNINGWARNING
WARNINGWARNING
WARNING
CheckCheck
CheckCheck
Check
Ensure that the battery leads and terminals are not excessively
corroded. If necessary, use a wire brush to clean them.
6.8 BATTERY6.8 BATTERY
6.8 BATTERY6.8 BATTERY
6.8 BATTERY
WARNINGWARNING
WARNINGWARNING
WARNING
ATTENTIONATTENTION
ATTENTIONATTENTION
ATTENTION
When removing the battery, the engine mustWhen removing the battery, the engine must
When removing the battery, the engine mustWhen removing the battery, the engine must
When removing the battery, the engine must
be off and the ignition key must not be in thebe off and the ignition key must not be in the
be off and the ignition key must not be in thebe off and the ignition key must not be in the
be off and the ignition key must not be in the
ignition switch.ignition switch.
ignition switch.ignition switch.
ignition switch.
RemovalRemoval
RemovalRemoval
Removal
To replace the battery, proceed as follows:
§ Rest the vehicle on its centre stand and on level ground.
§ Ensure that the ignition key is not inserted into the ignition switch.
§ Remove battery cover
«A»«A»
«A»«A»
«A» by looseing the two screws below
than release the three upper side tabs.
§ Disconnect the leads
«1»«1»
«1»«1»
«1» starting from the negative lead
««
««
«
--
--
-
»»
»»
»
followed by the positive
«+»«+»
«+»«+»
«+».
§ Loosen the screw shown and remove the retaining bracket «B».
§ Remove the battery.
Fig.13_06Fig.13_06
Fig.13_06Fig.13_06
Fig.13_06
Fig.14_06Fig.14_06
Fig.14_06Fig.14_06
Fig.14_06
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLE

Table of Contents

Related product manuals