Quadro 350D - 6.13 BRAKE FLUID

70
TOP UPSTOP UPS
TOP UPSTOP UPS
TOP UPS
If the coolant level drops below the TOP mark, allow the engine to
cool down, lift the footrest mat
«2»«2»
«2»«2»
«2», and remove the expansion tank
«3»«3»
«3»«3»
«3» filler cap
«4»«4»
«4»«4»
«4».
Coolant fluid: Coolant fluid:
Coolant fluid: Coolant fluid:
Coolant fluid: CUNA NC 956-16
If you find yourself having to frequently top up the coolant level, you
must have an
Authorised Service Centre Authorised Service Centre
Authorised Service Centre Authorised Service Centre
Authorised Service Centre carefully inspect your
vehicle’s cooling system.
WARNINGWARNING
WARNINGWARNING
WARNING
To avoid burns, do not remove the expansion tankTo avoid burns, do not remove the expansion tank
To avoid burns, do not remove the expansion tankTo avoid burns, do not remove the expansion tank
To avoid burns, do not remove the expansion tank
filler cap when the engine is still hot.filler cap when the engine is still hot.
filler cap when the engine is still hot.filler cap when the engine is still hot.
filler cap when the engine is still hot.
6.13 BRAKE FLUID6.13 BRAKE FLUID
6.13 BRAKE FLUID6.13 BRAKE FLUID
6.13 BRAKE FLUID
Level ChecksLevel Checks
Level ChecksLevel Checks
Level Checks
You must always check the brake fluid level before riding and in
accordance with the scheduled maintenance chart (see page 77).
Please note that the level of the fluid inside the reservoirs will
decrease progressively as the brake pads wear out.
Before topping up with new brake fluid, check the lining thickness of the
brake pad. If this is found to be below the minimum, please contact your
nearest Authorised Service Centre.
Rest the vehicle on its centre stand and on level ground.
Ensure that the brake fluid level is never below the minimum level marking.
Fig.24_06Fig.24_06
Fig.24_06Fig.24_06
Fig.24_06
Fig.25_06Fig.25_06
Fig.25_06Fig.25_06
Fig.25_06
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLE