73
Brake discsBrake discs
Brake discsBrake discs
Brake discs
n Rest the vehicle on its centre stand and on level ground.
n Using a Vernier calliper, check the thickness of the brake disc.
n If the thickness is lower than the wear limit, have your disc
replaced by an Authorised Service Centre.
Front disk thickness: 4 mm Wear limit: 3.5 mmFront disk thickness: 4 mm Wear limit: 3.5 mm
Front disk thickness: 4 mm Wear limit: 3.5 mmFront disk thickness: 4 mm Wear limit: 3.5 mm
Front disk thickness: 4 mm Wear limit: 3.5 mm
Rear disk thickness: 4 mm Wear limit: 3.5 mmRear disk thickness: 4 mm Wear limit: 3.5 mm
Rear disk thickness: 4 mm Wear limit: 3.5 mmRear disk thickness: 4 mm Wear limit: 3.5 mm
Rear disk thickness: 4 mm Wear limit: 3.5 mm
Riding with brake pads worn beyond the limit statedRiding with brake pads worn beyond the limit stated
Riding with brake pads worn beyond the limit statedRiding with brake pads worn beyond the limit stated
Riding with brake pads worn beyond the limit stated
above may cause the pad itself to come into directabove may cause the pad itself to come into direct
above may cause the pad itself to come into directabove may cause the pad itself to come into direct
above may cause the pad itself to come into direct
contact with the brake disc, damaging the disc.contact with the brake disc, damaging the disc.
contact with the brake disc, damaging the disc.contact with the brake disc, damaging the disc.
contact with the brake disc, damaging the disc.
ATTENTIONATTENTION
ATTENTIONATTENTION
ATTENTION
Fig.30_06Fig.30_06
Fig.30_06Fig.30_06
Fig.30_06
Fig.31_06Fig.31_06
Fig.31_06Fig.31_06
Fig.31_06
Do not ride the vehicle immediately after replacingDo not ride the vehicle immediately after replacing
Do not ride the vehicle immediately after replacingDo not ride the vehicle immediately after replacing
Do not ride the vehicle immediately after replacing
the brake pads. You must first apply the brake leverthe brake pads. You must first apply the brake lever
the brake pads. You must first apply the brake leverthe brake pads. You must first apply the brake lever
the brake pads. You must first apply the brake lever
several times until the calliper pistons settle and theseveral times until the calliper pistons settle and the
several times until the calliper pistons settle and theseveral times until the calliper pistons settle and the
several times until the calliper pistons settle and the
correct lever travel is restored.correct lever travel is restored.
correct lever travel is restored.correct lever travel is restored.
correct lever travel is restored.
ATTENTIONATTENTION
ATTENTIONATTENTION
ATTENTION
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLEMAINTENANCE VEHICLE
MAINTENANCE VEHICLE
If the lining thickness of any pad is less than 1.5 mm (0.06 in),
replace all the pads on the wheel.
To Next Page
Loading...
