31
4
Engine coolant
This check must be performed with the
engine cold and the scooter on a level
surface.
Perform this check on a level surface
(0°), with the scooter vertical (90° with
respect to the ground).
If you fi nd you regularly
need to top up the coolant, have
the cooling system inspected by
an authorised Quadro dealer or
service centre.
fi g. 2
Proceed as follows in order to access
the coolant reservoir and check the cool-
ant level:
• Remove cover A fi g. 2 by unscrew-
ing screws B and C
• Extract the cover of the HTS lock/
release lever
• Check that the coolant in the reser-
voir is near the FULL mark fi g. 3
fi g. 3
To avoid burns, do not
remove the coolant reservoir cap
with the engine hot.
• If it is necessary to top up the cool-
ant, remove the cap A fi g. 3 from the
reservoir to access it, or contact an
authorised Quadro dealer or service
centre
• Refi t the cover following the same
procedure in reverse
To Next Page
Loading...
