13.6kg
(30lbs)
RATED
2 Year Limited Warranty2 Year Limited Warranty
Version: January 2016
Version: January 2016
PRB-717-WHT
Roll Adjustment
To make Roll adjustment, first ensure that weight of the projector is supported.
Then loosen both M6x70mm bolts with the supplied Allen Key (E) and Wrench (F),
and adjust to your desired position. Re-tighten both screws firmly.
Roll +/-20°
Rotation/Shift Adjustment
To make Rotation / Shift adjustment(s), first ensure that weight of the projector is
supported. Then loosen the center M6x16mm screw slightly with the supplied
Wrench (F), and adjust to your desired position. Re-tighten the screw firmly.
Rotation 360°
Shift 1"
If you have any questions regarding any of the instructions or warnings, please contact your
local distributor directly (OR) contact QualGear technical support via email at
support@qualgear.com.
11
Adjusting the Projector (Part 2 of 2)4
F
F
E
To Next Page
Need help?
General
