Qualitrol SERVERON TM1 - Monitor Installation; Site Preparation

810-1902-03 Rev D TM1 Installation Guide
7
Monitor Installation
CAUTION: Do not attempt to install your TM1 On-Line Transformer Monitor until you have read and
fully understand the procedures outlined in this document.
Installation of the TM1 consists of the following:
 Site preparation
 Mounting the monitor
 Wiring the monitor
 Bleeding air from the monitor
 Configuration
Site Preparation
NOTE: Serveron recommends a minimum size of 1” for the transformer oil supply valve and a minimum of
6” vertical clearance between the valve centerline and the transformer foundation for proper installation space.
Ensure the following prior to mounting the monitor:
 An adequate valve location for mounting the TM1 monitor has been identified
 Power is present and available at the installation site for the monitor
 Transformer is oil-filled
 All shipped items have been located
Tools / Materials Required
The following tools are required for installation of the TM1 monitor:
 7/16”, ½” and 1 ½” wrenches (or an adjustable wrench)
 1/8”, 3/16”and 3/32” Allen keys (3/16” Allen key used for optional Moisture Kit only)
 Small flat-blade screw driver
 Large flat-blade or Phillips screwdriver
 Teflon tape and pipe-thread sealant
 Wire strippers/cutters
 Container to collect oil during installation
 Pipe wrench