Performing additional connections
Connecting audio components
Connect the audio component into the audio jack of your CTL Meet
Compute System.
Connecting to local area network (LAN)
1.
Connect one end of the RJ-45 cable to the LAN port of your
CTL Meet Compute System.
2.
Connect the other end of the RJ-45 cable to a network
connection device or a network wall connector.
» NOTE: For configuring LAN parameters, refer to page 24.
Connecting USB devices
» NOTE: Your CTL Meet Compute System supports USB2.0, USB3.0, and USB type-C.
Depending on the supported USB type, connect the USB device to the
respectful USB port of your CTL Meet Compute System.
•
USB2.0 and USB3.0 compatible device connect to one of the
following USB ports:
•
USB type-C compatible device connect to the following USB port:
GETTING STARTED
15
To Next Page
Loading...
Need help?
General