DAE/Veeam Memory Module Installation
Quantum DXi4700 Installation Guide 79
3. Close the browser window.
4. After the Node shuts down, turn off both power switches on the back of all installed Expansion modules
(JBODs) (see Figure 65 below).
Figure 65: Expansion Module Power Switches - DXi4700
1 - Power Switches
Opening the Node Cover
To open the DXi4700 Node cover:
1. Set the Node on a flat, stable surface.
2. Make sure that no cables (power, Ethernet, Fibre Channel, or SAS) are connected to the Node.
3. Press and hold the power button on the front of the Node for three seconds to fully drain the system of
stored power prior to removing the cover (see Figure 66 below).
Figure 66: Node Power Button
1. Power Button
4. On the Node cover, rotate the latch release lock counterclockwise to the unlocked position (see Figure
67 on the next page).
To Next Page
Loading...
