Quantum QXS-312 - Bezel; Drive Front Panel Components; Drive RAID Chassis: Rear Panel Components

30 QXS Site Planning Guide
Bezel
The QXS 2U drive chassis includes a bezel sub-assembly that attaches to the front panel of the
chassis. The bezel, comprised of a vented cover attached to an electro-magnetic interference (EMI)
shield, is pre-assembled and packed within a box contained in the enclosure master shipping
container.
Instructions for attaching/removing the bezel are provided in the
QXS Bezel Installation Guide .
CAUTION: The bezel should be properly installed while the chassis is in operation to ensure
adequate EMI protection for the drives.
48 Drive Front Panel Components
Figure 24 provides the 2U48 drive chassis (for the RAID or expansion chassis) with the bezel removed.
Figure 24 2U48 Drive Chassis (Bezel Removed)
48 Drive RAID Chassis: Rear Panel Components
Figure 25 provides a representative example of the 48 drive RAID chassis (rear panel components).
Figure 25 48 Drive RAID Chassis: Rear Panel Components
1 Chassis ID LED 2 Thumbscrew (for securing or accessing drawers)
3 Disabled Button (used by engineering only) 4 Drawer Handle (shown in stowed position)
5 Drawer Status LED: FRU OK 6 Drawer Status LED: Fault/Service Required
7 Drawer Status LED: OK to Remove 8 Drawer Status LED: Unit Locator
CACHE
LINK
ACT
CACHE
LINK
ACT
CLI
CLI
PORT 2 PORT 3
S ERVICE−2S ERVICE−1
PORT 0 PORT 1
CLI
CLI
PORT 2 PORT 3
S ERVICE−2S ERVICE−1
PORT 0 PORT 1
EXP 0 EXP 1
6Gb/s
S
S
A
LINK 0
LINK 1
EXP 0 EXP 1
6Gb/s
S
S
A
MGMT
MGMT
LINK 0
LINK 1
1 1
2
2
3
4
1 AC Power Supplies (qty. 2) 2 AC Power Switch (qty. 2)
3 Controller I/O Module A 4 Controller I/O Module B