QXS-4 Series Specifications 21
Bezel
The QXS 4U drive chassis includes a bezel sub-assembly that attaches to the front panel of the
chassis. The bezel, comprised of a vented cover attached to an electro-magnetic interference (EMI)
shield, is pre-assembled and packed within a box contained in the enclosure master shipping
container.
The bezel might include a removable air filter that can be serviced or replaced. Instructions for
attaching/removing the bezel, and for servicing or replacing the air filter, are provided in the
QXS
Bezel Installation Guide
.
CAUTION: Whether configured with or without an air filter, to ensure adequate EMI protection for
the drives, the bezel should be properly installed while the chassis is in operation.
56 Drive Front Panel Components
Figure 19 provides the 4U56 drive chassis (for the RAID or expansion chassis) with the bezel removed.
Figure 19 4U56 Drive Chassis (Bezel Removed)
1 Chassis ID LED 2 Thumbscrew for securing or accessing drawer
3 Drawer handle (shown in stowed position) 4 Drawer status LED: Unit Locator
5 Drawer status LED: OK to Remove 6 Drawer status LED: Fault/Service Required
7 Drawer status LED: FRU OK 8 Chassis status LED: Unit Locator
9 Chassis status LED: Fault/Service Required 10 Chassis status LED: FRU OK
11 Chassis status LED: Temperature Fault
To Next Page
Loading...
