Interpret 2U12 and 2U24 operator's panel LEDs 44
Interpret controller module LEDs 45
Interpret SAS 12Gb/s expansion input/output module LEDs 46
7 Operation of 5U enclosures 48
Apply power to the 5U enclosure 48
Remove power from the 5U enclosure 50
Interpret system LEDs 50
Interpret 5U enclosure operator's panel LEDs 50
Interpret drawer LED panels 51
Interpret controller module LEDs 52
Interpret SAS 12Gb/s expansion input/output module LEDs 54
8 Storage enclosure management 56
Command-line interface usage 56
Install a device driver 57
Configure the management host for serial communication 57
Connect to a controller module for configuration 60
Disk Storage Management Utility usage 62
Access the web-based management interface 62
Complete the preboard and onboard process 63
Storage volume replication 63
Co-located replication configurations 64
Remote replication configurations 66
Set up storage volume replication 67
9 Hardware installation and configuration issues 68
Address initial start-up issues 68
Interpret storage and expansion enclosure fault LEDs 69
2U12 and 2U24 enclosure fault LEDs 69
5U84 enclosure fault LEDs 74
Identify 2U enclosure fault conditions 79
Identify 5U enclosure fault conditions 80
Isolate hardware and connectivity faults 81
Isolate replication faults 82
Isolate system application faults 84
Take corrective action for 2U enclosures 84
Take corrective action for 5U enclosures 86
10 In-service field maintenance for 2Uenclosures 90
Replace a 2U enclosure drive module in its carrier 91
Replace a 2U enclosure controller module 93
Replace a 2U power cooling module 95
iiiContents
To Next Page
Loading...
Need help?
General
