Quantum QXS Series

Chapter 8 Storage enclosure management 67
Figure 50 Sample of two remote sites, each with a controller enclosure, switch, and its own host server
Set up storage volume replication
After meeting all storage volume replication prerequisites and properly cabling the related primary and
secondary system, use the command-line interface (CLI)the DSMU to set up the replication feature.
IMPORTANT Familiarize yourself with all replication-related content in the Storage Management Guide
before you begin.
To set up storage volume replication using the CLI:
1. Find the port address on the secondary system.
show ports
2. Verify the primary system can communicate with the secondary system.
query peer-connection
3. Create a peer connection.
create peer-connection
4. Create a virtual replication set.
create replication-set
5. Replicate the volume.
replicate
You may also follow the same steps in the DSMU Replications topic by selecting the related actions in the
described sequence.