Quectel AG35 SMTP - AT+QSMTPPUT Send an Email

LTE Module Series
AG35 SMTP AT Commands Manual
AG35_SMTP_AT_Commands_Manual Confidential / Released 17 / 30
Parameter
Example
AT+QSMTPCLR //Clear the recipients, subject, body and attachments for
the email.
OK
AT+QSMTPDST? //Query the recipients of the email.
OK
AT+QSMTPSUB? //Query the subject of the email.
+QSMTPSUB: 0,""
OK
AT+QSMTPATT? //Query the attachments of the email.
OK
2.7. AT+QSMTPPUT Send an Email
It may take some time for an email to be completely sent, which depends on the total size of attachments
and network status. Customers should not send email again before receiving “+QSMTPPUT:
<err>,<protocol_error>” which indicates the ending of sending an email. If <err> is not 0, the email can be
resent by executing AT+QSMTPPUT=<timeout> directly.
Execution Command
AT+QSMTPCLR
Response
OK
Or
+CME ERROR: <err>
<err> Integer type. The error code of the operation. Please refer to Chapter 5.
AT+QSMTPPUT Send an Email
Test Command
AT+QSMTPPUT=?
Response
+QSMTPPUT: (60-65535)
OK
Write Command
AT+QSMTPPUT=<timeout>
Response
If the format is correct and it is not sending an email:
OK
+QSMTPPUT: <err>,<protocol_error>
Quectel
Confidential