NB-IoT Module Series
BC660K-GL Log Capture Guide
BC660K-GL_Log_Capture_Guide 15 / 24
4.3. Logging Port Baud Rate Configuration
It is necessary to select the logging port and a baud rate on EPAT and execute AT+QCFG on the PC to
configure the baud rate of the logging port while ensuring the configurations are consistent.
After “Serial Device” is selected, the window below will appear, click “Settings” for port setting.
Figure 5: Select Device
Select the logging port and its baud rate:
Figure 6: Select Port and Baud Rate
To Next Page
Loading...
