Quectel BC660K-GL - 2 Preparation; Bc660 K-Gl-Te-B

NB-IoT Module Series
BC660K-GL Log Capture Guide
BC660K-GL_Log_Capture_Guide 8 / 24
2 Preparation
This chapter describes the tools, drivers and the runtime environment of EPAT required for capturing logs
of the module.
The tools and drivers listed below are required:
⚫ TE-B of the module
⚫ QCOM of version 1.6 or later: Serial port communication tool.
⚫ EPAT: Log capture tool
⚫ USB-UART Driver: Ensure the port is available for use.
⚫
For the use of the QCOM tool, see document [1].
2.1. BC660K-GL-TE-B
The BC660K-GL-TE-B is shown in the figure below.
NOTE