Quectel LC29H - Test with QGNSS Tool; COM Port and Baud Rate Setting

GNSS Module Series
LC29H(AA,BA,CA,DA,EA)_EVB_User_Guide 16 / 24
5 Test with QGNSS Tool
This chapter explains how to use the QGNSS software tool for checking the status of a GNSS receiver.
For more information about QGNSS use, see document [2].
Download the QGNSS tool from our website Download Zone, or request it from Quectel Technical Support.
5.1. COM Port and Baud Rate Setting
Step 1: Assemble the EVB Accessories.
Step 2: Flip the Power switch (S201) to ON position to power on the EVB.
Step 3: Start the QGNSS and click “Setting” and “Serial Port Configuration” (default baudrate:
115200 bps
2
).
Figure 7: QGNSS Setting
Step 4: Click the “Connect or disconnect” button. The interface shown in the figure below appears
2
UART interface default settings vary depending on software versions. Please see specific software versions for details.