Pronto! 482/486/682/863 13-7
Cleaning Interval
The Cleaning interval function is used for additional printhead maintenance
control. The length of medium which passes the printhead can be selected in
increments of 100 m after which the printhead is to be cleaned.
1 Press the menu button.
2 Select Service > Cleaning interval menu.
3 Press the ↵ button.
4 Select the desired value with the left/right arrow buttons or select Off to
deactivate the Cleaning interval function.
5 Press the ↵ button.
If the set length of the medium (label strip, transfer ribbon) has passed the
printhead and an error occurs in the fl ow of the medium (e.g. label end,
transfer ribbon end), the Clean printhead! message appears in the display.
The error message for the error which occurred is not displayed until the
Clean printhead! message is acknowledged. As long as no errors occur in the
medium fl ow, no messages are displayed and the print job is continued even
if the cleaning interval has passed.
To Next Page
Loading...
Need help?
General
