Pronto! 482/486/682/863 5-5
Printing parameters
1 Press the menu button.
2 Select Setup > Print param.
Time Powersave. Time between the last operation and the
activation of Powersave mode.
5 min.
Debug mode Operating mode which supports the
firmware programmer when localizing
errors.
Off
Parameter Meaning Default
Heat level Heating value for compensating for the
differing thermal behavior of printheads.
Changing this value is then especially
necessary if the printing intensity has
changed after replacing the printhead.
To adapt the printing intensity when using
different media, print speeds or printing
contents, you should change the heat level
in the software. The settings from the Print
param. menu and the software are added
together.
The heat level setting also affects the test
printouts.
0
Print speed Basic print speed setting.
You can re-specify the print speed for each
print job via software. The basic setting is
not changed by this.
The print speed setting also affects the test
printouts.
100 mm/s
Parameter Meaning Default
To Next Page
Loading...
Need help?
General
