Quicksilver 875SD User Manual

Quicksilver 875SD — General Informaon
14
Please note that operator vision from the helm may be obstructed by high trim angles of the cra,
along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load
distribuon, speed & acceleraon, transion from displacement to planing mode, sea condions, rain
and spray, darkness and fog, interior lights, posion of tops and curtains, and persons or movable
gear in the operator’s eld of vision.
Dash Switch Panel
Horn
Forward bilge pump
A bilge pump
Navigaon lights
14. Navigaon Lights
Your boat comes equipped with navigaon lighng for use at night or in low visibility condions. Prior
to running at night, you must install the stern pole light into the socket located on the a backrest. A
three posion switch, located at the helm switch panel, controls the navigaon lights. To turn on the
Navigaon Lights, push the upper part of the switch forward. This illuminates on the port (red),
starboard (green) and all around light (white) showing other vessels that you are underway. To turn on
the Anchor Light, push the lower part of the switch down. This illuminates the all around light (white),
leng other boaters know that you are anchored at a given locaon.
Navigaon Lights “OFF”
Navigaon Lights “ON”
Anchor Light “ON”
Navigaon light switch
The Internaonal Regulaons for Prevenng Collisions at
Sea (COLREG) and the rules of the road require that a
proper lookout be maintained at all mes and observance
of right of way be respected. Always be certain to have
sucient distance to stop or maneuver if required to avoid
collisions.
Courtesy lights
Water pump
Windshield wiper
Windshield washer uid
Underwater lights
Bow windlass
USB charger ports

Quicksilver 875SD Specifications

General

Brand	Quicksilver
Model	875SD
Category	Boat
Language	English