Quicksilver 875SD

35
Quicksilver 875SD — System & Component Overview and Operaon
Anchor Windlass
Bow windlass
Hand held controller
Windlass switch
Windlass breaker
and allows the anchor to be deployed into the water. The speed of the rode can be adjusted by
turning the handle clockwise. To re-engage the clutch and lock the rode from moving, turn the handle
clockwise.
To manually raise the anchor, loosen the clutch by turning the handle counter-clockwise, and pull the
anchor up into the boat. Make sure to properly feed the rode and chain through the windlass when
pulling up the anchor. When the anchor is up and stowed properly in the bow pulpit, re-engage the
clutch by turning the handle clockwise.
11. Bow Thruster (oponal)
The electric bow thruster assists with the maneuvering of your vessel when docking. Access to the
motor and baery is via the forward berth storage area, while the baery switch is located inside the
interior liner oor access panels.
Operaon from the helm
To operate the thruster, you rst must turn the thruster baery switch to the ON posion. At the
helm, press the on/o switch on the control panel. An LED will ash and a buzzer will sound
connuously. Press the on/o switch again within 6 seconds . The system will conrm that it is ready
for use when the LED light remains green and the buzzer sounds twice.