Quicksilver 875SD User Manual

Quicksilver 875SD — Electrical Systems
55
Use only fuses and breakers having the same amperage
rang as the original or as specied. Use of higher
amperage fuses or breakers is a re hazard.
the electrical load of the equipment it is connected to and will cause nuisance failures. If a fuse or
breaker is replaced with one that has a higher amperage, it will not provide protecon against an
electrical malfuncon and could create a possible re hazard.
Fuses and breakers
ATO/ATC fuse Thermal breaker ANL fuse Magnec breaker
DC Helm Panel
Horn breaker — 5 Amp
A bilge breaker — 3 Amp
Forward bilge breaker — 3 Amp
Navigaon lights breaker — 3 Amp
Underwater lights — 10 Amp
Windshield wiper — 5 Amp
Windshield washer — 5 Amp
Courtesy lights breaker — 3 Amp
Water pump — 10 Amp
USB outlet — 3 Amp
12V outlets breaker — 10 Amp
Stereo breaker — 10 Amp
GPS / Electronics breaker — 10 Amp
Trim tab breaker — 15 Amp
Cabin lights —3 Amp
Spare — 10 Amp
The 875SD has a breaker panel at the helm, located below the steering wheel. There are also
addional breakers located on the baery switch panel.

Quicksilver 875SD Specifications

General

Brand	Quicksilver
Model	875SD
Category	Boat
Language	English