Quicksilver 875SD User Manual

Quicksilver 875SD — Electrical Systems
58
Shore power cord should be secured or routed to avoid
laying or falling in the water, and to avoid stress on the
shore power plug and inlet.
The use of extension shore power cords is not
recommended. Power core extensions can cause a voltage
drop and prevent some devices from operang correctly.
Turning O and Disconnecng Shore Power
To disconnect shore power:
On the Boat
1. Make sure that the all of the breakers on the AC Distribuon Panel are OFF
On the Dock
1. Turn OFF the dock breaker.
2. Disconnect the dockside end of the power cord.
On the Boat
1. Disconnect the power cord from the shore power receptacle.
2. Clean the power cord, spray the plugs with a moisture repellent and store the cord in a dry
locaon on the boat.
You must keep the shore power cord and plug ends clean and dry. This is especially necessary if your
boat is used in salt water. Always clean and spray your cord ends with moisture repellent before using
and before storing the cord.
AC Panel
Voltmeter
Reverse polarity indicator
Main breaker switch — 16 Amp
Main test buon
Baery charger breaker switch — 10 Amp
Outlets breaker switch — 7 Amp
Cooktop breaker switch — 16 Amp
Air condioner breaker switch — 10 Amp
Water heater breaker switch — 10 Amp
Microwave breaker switch — 6 Amp

Quicksilver 875SD Specifications

General

Brand	Quicksilver
Model	875SD
Category	Boat
Language	English