2012 2039 28 103
5.3 Starting
Procedure
For the position of the air outlet and the drain connections, see sections Introduction.
Control panel
1. Open the air outlet valve.
2. Switch on the voltage. Check that voltage on LED (8) lights up.
3. Press start button (14) on the control panel. The compressor starts running and the automatic operation LED
(7) lights up. After the start-up cycle, the compressor starts running loaded.
5.4 During operation
The operator must apply all relevant Safety precautions. Also consult section Problem
solving.
Keep the doors closed during operation; they may be opened for short periods only to
carry
out checks
When the motors are stopped and LED (7) (automatic operation) is a light, the motors
may
start automatically
To Next Page
Loading...
