Quintel QS Series MultiServ User Manual

MultiServ Multiband Antennas
QS Series Antenna Installation Guide
INS-AS-004024_E Page 13
8 AISG & RF Connections for 8-port Antennas, SBT and non-SBT
versions
These diagrams refer to 8-port models of all lengths. The antennas are factory configured for AISG 2.0.
The Device type classification is Type 1.
All AISG RET Devices are communicating through the single or dual input and output DIN connectors or using
“AISG over RF” on the antenna connector plate as shown below.
Wire the AISG connections and attach the antenna jumpers according to the RFDS (Radio Frequency Design
Specification) supplied by engineering.
Non-SBT Option
AISG output for
daisy-chain.
AISG input from
home run cable
or daisy-chain.
High-band
AISG output for
daisy-chain.
High-band AISG
input from home
run cable or
daisy-chain.
Low-band
AISG input
from home
run cable or
daisy-chain.
Low-band AISG
output for
daisy-chain.
High-band
AISG over
RF input.
Low-band
AISG over
RF input.
SBT Option
Figure 13: AISG & RF Connections for 8-port Antennas
Example Above

Quintel QS Series MultiServ Specifications

General

Brand	Quintel
Model	QS Series MultiServ
Category	Antenna
Language	English