Quooker Scale Control Plus - Activating the Meter; Setting Water Hardness; Setting Tank Type; Using the Meter

5
7 8
6
5. Activating Scale Control Plus Meter
Initially activate the Scale Control Plus
Meter by pressing the wheel until the
screen lights up.
6. Setting water hardness
Turn and press the wheel to input the
water hardness (found using the steps in
part D). Press the wheel again to conrm.
7. Setting tank type
Turn the wheel again to set the power
(in kW) in correspondence with the type
of tank you have (see table below). Press
the wheel when the correct value is
highlighted. Press again to conrm.
8. Using the Scale Control Plus Meter
After setting the meter, ‘100%’ will appear
on the screen. This percentage represents
the lifespan of the cartridge and will slowly
count down to ‘0%’. When this happens,
the meter sounds an alarm signal that the
cartridge needs replacing.
PRO3 1.6 kW
PRO7 2.9 kW
COMBI 2.2 kW