Radar Systems Prism2 - Page 58

57
Note: Please use the Connection troubleshooter if the error message
appears.
9. Configure new IP address of your computer compatible with the new IP address
of Control Unit you set.
Resetting the default IP address of Control Unit
If you have forgotten or lost the Control Unit IP address, you can reset it to the
default (192.168.0.10). To reset default IP address:
1. Configure your computer according to p.8 of present User’s Manual.
2. Turn ON the Control Unit, wait about 3 seconds and press the RESET button
on the front panel of the Control Unit.
Connection troubleshooter
Error code IP001. “The Control Unit with IP address … is unreachable!”
Possible reasons
What to do
1.
Entered IP address is not correct.
Reenter IP address and try again your action.
2.
Computer is not configured.
Configure your computer according to p.8 of
present User’s Manual.
3.
Control Unit has unknown IP.
Reset default IP address (192.168.0.10) of the
Control Unit according to p.55 of present User’s
Manual
4.
Control Unit is switched off.
Switch on the Control Unit and try again your
action.
5.
The Ethernet cable is unplugged.
Plug in Ethernet cable.
6.
The Ethernet cable is broken.
Use another Ethernet crossover cable.
Error code IP002. “Error in writing into Flash Memory”
Possible reasons
What to do
1.
Connection timeout
Try again your action.
2.
Control Unit is failed.
Contact your dealer or producer for repair.