7
5. Software Installation in Computer
To install “Prism2” Package on the hard disk of the computer sequentially perform the
following operations:
Insert “Prism2” CD in the computer CD-ROM.
If Auto Run is disabled, Press button Start on the main panel and then press Run (if
there is no Run at you Start menu you can always press Windows Key + R); type
d:\setup in Open line of appeared Run window, where d is the letter of your disk
drive, and then press button OK.
Follow instructions of the installation program. When asked, enter the Activating code
that is attached to the CD. You can also get activating code via E-mail, phone or fax.
5.1. Configuring the computer for wire connection with Zond-12e Georadar
Control Unit
Starting from 2015 “Zond-12e Advanced” GPR (serial numbers from 0537) contains
internal network router that is able to automatically configure Local Area Connection
settings on your (every version of Windows starting from Windows XP are configured to
“Obtain an IP address automatically”). For “Zond-12e Single Channel”, “Zond-12e Double
Channel” or earlier versions of “Zond-12e Advanced” GPRs or if you for any reason have
changed the Local Area Connection settings, you will have to manually configure them to be
able to connect to the “Zond-12” GPR. To do so, you need:
For Windows XP:
1. Click the Start button, point to Settings and then click Control Panel.
2. Double click the Network connections icon.
3. Double click your Local Area Connection icon and then click Properties button.
4. Select Internet protocol [TCP/IP] and click the Properties button.
5. For GPRs manufactured after 2015 - click the Obtain an IP address
automatically option and continue from the point 9.
6. For GPRs manufactured before 2015 - click the Use the following IP address
option.
7. Click the IP Address box and enter 192.168.0.2 (if this address is occupied or is not
accessible, you could use any address from 192.168.0.2 to 192.168.0.254, except
occupied address 192.168.0.10. Please, consult with your network administrator
before changing IP addresses).
8. Click the Subnet mask box and enter 255.255.255.0.
9. Press OK button.
10. Press Close button.
For Windows Vista / 7:
1. Click the Start button, and then click on the Control Panel.
2. Chose the sub item View network status and tasks, of Network and Internet item.
3. Click the link Change adapter settings in the left part of Network and Sharing
Center.
To Next Page
Loading...