63
Fig.C4. PrismClicker Press Setup dialog window
Press “OK” to apply the Press Setup configuration.
How it works
Software is ready for using after all configurations. To start it working, you have to
run the Prism2 software on the host computer and PrismClicker on the remote one. Be
sure that both computers are connected physically (by the serial, Ethernet or Wi-Fi
communication) and go to the acquisition mode of the Prism2 software. The GPR has to
be turned on and reachable for the Prism2 software. By the way, you is able to use the
same GPR Wi-Fi network ("Zond", "Python", etc.), which is used for a host computer
communication with the GPR, for communication between the host (operating Prism2)
and remote (operating PrismClicker) computers (take a look on the part 5.2. for computers
configuration of this manual for details, if you are going to use manual TCP/IP
configuration, remember that IP addresses cannot be the same for different devices).
PrismClicker automatically is trying to connect to the host computer at the start. If the
connection is not established, application shows the error message with suggestion to
reconnect it. If it happens, user has to click on the tray icon and press “Reconnect” button
(if it fails to reconnect “Connection Setup” dialog window appears).
Press any setuped buttons in the Prism2 software acquisition mode to take a look
on the PrismClicker result. If everything is OK, PrismClicker emulates the left mouse
clicks on the marked places: running/closing/pressing/checking any third party software or
its components.
To Next Page
Loading...