10A96 Ion chamber Adapter
This adapter adapts the 10X5 ion chambers to
the 9660 ion chamber digitizer. It contains a
microprocessor that translates between the
jumpers, resistors and potentiometer located
within the probe stem of 10X5-series ion
chambers into signals that mimic the EAROM
that holds calibration and chamber-type
information the Accu-Pro™ requires. A
temperature sensor is included to provide that
information also. Its diameter is slightly larger
than that of the chamber stem, with a hard-
mounted microdot connector on one end and a
9096-style connector on the opposite end. It
draws power from the 9660 Ion Chamber
digitizer.
90E6-2 - Extension cable
The extension cable allows one to place the ion chamber up 2 meters away from the digitizer. (Other
lengths available)
44
To Next Page
Loading...
Need help?
General
