Main Menu
Create – Allows user to create a new meter test setup.
Delete – Allows user to delete a meter test setup.
Preferences
RM-111 Link Mode – Puts the RM-111 in a communication mode, allowing Radian data
collection and confi guration software applications to completely take control of the RM-111. The
RM-111 must be in this mode to either upload or download test information and results.
Results Display – Selects either percent registration or percent error.
Result Digits – Selects results resolution-either one, two, or three places to the right of the
decimal point.
Kh Format – Allows the user to select the Kh format in the test setups screen – Pulses/Wh or
Wh/pulse.
User Prompts – Specifi c meter and tester information is entered to enhance the test results. These
entries will also be stored with the results. All user prompts can be enabled or disabled directly
from the RM-111 YES/NO keys.
Enter Test Voltage – The service voltage of the meter under test.
Enter Test Amps – The test amps of the meter under test.
Enter Meter Form – The form number of the meter under test.
Enter Tester ID# - The tester’s identifi cation number, if applicable.
Enter Manufacturer ID# - The manufacturer’s identifi cation number, if applicable.
Enter Beep – Enables or disables the RM-111’s audible response.
20
To Next Page
