Radian RM-111 - Page 82

97 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

RM-111 Operations Manual

CANCEL key is pressed.

10. The RM-111’s display shows the pulses IN per the pulses OUT for as long as the test is ran.

For this application, there are no results and therefore no save option.

81

Application 12

Application 12

Table of Contents

Default Chapter4
- Table of Contents4
1 Product Introduction6
- Features7
2 Specifications9
- Physical9
- Electrical9
- Environmental9
- Accuracy10
- Inputs (Ports A, B, C and D)10
- Outputs (Port D Only)11
- Output Accessories11
- Electronic Relay Specification12
3 RM-111 Keypad Conventions13
- DC Input: 9-12V DC Adapter14
4 Menu Structure16
- Main Menu16
  - Results17
  - Preferences18
- Detailed Description of Menu Items20
  - Run Test20
  - Standard Test20
- Reference Standards (Open Collector)23
- Device under Test (D.U.T.)23
- Rm-1S23
5 Inputs23
- Rm-1P24
- Open Collector24
- RM-1R, Electronic/Mechanical Potential Relay24
6 Outputs (Port D Only)24
- Equipment Needed25
7 Testing a Standard Using the Average of One to Three Reference Watthour Standards25
- Testing a Radian Standard Using the Average of Three Inputs29
- Testing a Radian Standard30
8 True Three Phase Standard Testing31
- Testing a Polyphase Standard True Three Phase35
9 Testing a Radian Standard (Display Gating)36
- Testing an Electrommechanical Standard41
- Testing an Electromechanical Standard (Potential Gating)45
11 Testing an Electronic Standard with Taps (Potential Gating)46
- Testing an Electronic Standard (Potential Gating)50
12 Testing an Electronic Standard (Electronic Gating)51
13 Testing an Induction or Solid State Meter Via KYZ56
14 Testing a Solid State Meter Using Calibration LED Output or Induction Meter Using an Edge Test63
15 True Three Phase Meter Testing Using Customer Load70
- True Three Phase Meter Testing74
16 Testing the Accuracy of a Test Board (RM-1P Electronic Light Valve Option)75
17 Testing the Accuracy of a Test Board (Open Collector Option)78
18 Interfacing a Solid State Meter to a Test Board (Open Collector Option)81
- Interfacing a Solid State Meter to a Test Board83
19 Interfacing a Solid State Meter to a Test Board (RM-1P Electronic Light Valve Option)84
20 Pulse Constants and Kh Values for the RM-11187
21 Calculations88
- Testing Standards: Counting Pulses88
- Testing Standards: Potential Gating the Standard under Test88
- Series Single-Phase Meter Testing89
- True Three Phase Meter Testing (Using Customer Load)89
22 Testing Accessories90
23 Warranty Service97

Related product manuals

Preview: Radian RD-30