Radio Shack 15-309 - Auto Code Search

7
Setup
Auto Code Search
Auto Code Search automatically sends device codes to the device that you want to
control.
1. Power on the device that you want to control. For VCRs and DVD players, you must
insert a tape or disc.
2. Onyouruniversalremote,press and hold SET, then press and hold a device key
(TV, VCR/DVD or STB). Continue to hold down both keys for more than 3 seconds.
The red LED flashes and the universal remote starts searching. Release both
buttons.
3. When the device responds in any way (switches off, play, pause, volume change,
channel changes ), press any key other than SET within 2 seconds to confirm the
code. The red LED will stop flashing.
4. Verify the setup by testing various keys and functions. Press G on your universal
remote to turn on the device if it turned off in step 3. If some of your device’s
functions do not respond to the remote, repeat steps 2-4.
nNotes:
• BecauseAutoCodeSearchrequiresyoutostopthesearch,youmustremainwiththe
device during the process.
• Tostopsearching,pressanykey(exceptSET).Thered LED light turns off and search
stops.