14
6. Replace the meter in the holster.
When appears on the right side of the display, re-
place the batteries.
Warnings:
• To avoid electrical shock, disconnect both test leads
from any equipment before you remove the batteries.
• Do not operate the meter until you replace the batter-
ies and close the back cover.
Caution:
Never leave weak or dead batteries in the
meter. Even leak-proof types can leak and damage the
meter.
When you are not going to use the meter for a few
weeks, remove the batteries.
USING TEST LEADS
Use only the same type of test leads supplied with the
meter. These test leads are rated for 1200 volts. You can
order replacement leads from your local RadioShack
store.
22-178.fm Page 14 Friday, August 6, 1999 11:38 AM
To Next Page
Loading...
