4
Data Hold Function
— holds the display so you can see
the reading even after you disconnect the probes.
Overload and Transient Protection
— helps protect the
meter from overvoltage in most ranges.
Continuity Buzzer Function
— lets you quickly hear if
there is continuity in a cable or between two points.
Diode Check Function
— lets you safely check semi-
conductors for open, shorted, or normal junctions.
Auto-Polarity Operation
— protects your meter and
gives valid measurements even when you connect the
leads in reverse polarity.
Low-Battery Indicator
— shows when you need to re-
place the batteries.
Fold-Out Stand
— lets you adjust the meter’s position
for the best visibility on a flat surface.
Protective Holster
— protects the meter from damage
and lets you hang the meter on a wall.
Note:
Your multimeter requires two AA batteries (not
supplied).
22-178.fm Page 4 Friday, August 6, 1999 11:38 AM
To Next Page
Loading...
