Radio Shack CCR-81 Operation Guide

Step 4 below to load the Student Station System Software from cassette. (If a
Network 1 or Network 2 Controller is available, this software can be loaded into the
Student Stations from the Host computer following the directions on page 15.)
4
4. Connect the cassette recorder to the Student Station. Make sure the
recorder is plugged in.
5. Insert the backup copy of the Network 3 Student Station System Software
cassette into the cassette recorder.
6.
Set the volume on the cassette recorder at 6.
7. Press the REWIND button on the recorder. When the tape is rewound,
press STOP. Then press PLAY. (If the recorder is connected properly, it
should not come on at this point.)
8. When the screen reads: Type:
!ENTER!
!ENTER!
Cass?
Memory Size?
Ready
[§] [Y] [§] [TI ~ [M] I ENTER I
>_
*?
[§] [TI [ID [ID ~ [NJ [TI I ENTER I
The cassette recorder will come on and begin to load the program . (If the
program is loading properly, two asterisks will appear in the upper right
corner of the screen. The right asterisk will blink.)
If the asterisks do not appear after several seconds:
•
press the STOP button on the recorder
•
turn the volume on the recorder a little higher
•
press the orange Reset button on the computer
• repeat the instructions from Step 7 above.
If the asterisks appear, but the right one does not blink:
•
press the STOP button on the recorder
•
turn the volume on the recorder a little lower
•
press the orange Reset button on the computer
• repeat the instructions from Step 7 above.
If "D*" or "C*" appears on the screen, make a new backup copy of the Student
Station System Software cassette following the directions on page 36, and start
again from Step 4 above.
9.
When "*?" reappears on the screen, press [I] I ENTER!.

Radio Shack CCR-81 Specifications

General

Brand	Radio Shack
Model	CCR-81
Category	Desktop
Language	English