Radio Shack CCR-81 Operation Guide

10. "Baud rate?" will be displayed on the screen. Press I ENTER I. The screen will
now
display '' Network 3'' and a blinking cursor.
(Note:
Be sure to follow Steps 3 through 10 above at each Student Station.)
At the Host (Disk) Computer:
11. Make sure the computer is ON (the ON/OFF switch is under the right side
of
the keyboard).
12.
Insert the backup copy of the Network 3 software diskette in Drive 0 (the
bottom drive) with the label facing up and the square notch to the left,
close
the disk drive door, and press the orange Reset button.
13. Type the date, using two digits each for the month, day, and year, with a
slash separating each pair. (Example: [I] 00 [Z] [I] [I] [Z] [I] ~ for September
1, 1982.) Then press I ENTER L When asked for the time, simply press
I ENTER I. (The computer will ask for the date and time only after it is first
turned on.)
14.
When "TRSDOS Ready" appears on the screen, type [HJ [Q] [I] [!] I ENTER L
15. When "Baud rate?" appears on the screen, press I ENTER L * The screen
should now display:
* The baud rate is the rate at which information is transferred between the Host computer
and the Student Stations. When I ENTER I is pressed in response to the "Baud rate?"
question, the fastest rate (9600 baud) is used. Other rates which may be chosen include
300, 600, 1200, 1800, 2400, 3600, 4800,
and 7200 baud. The Host computer and the
Student Stations must be set at the same baud rate for accurate transfer of information
between
the Host computer and the Student Stations.
5

Radio Shack CCR-81 Specifications

General

Brand	Radio Shack
Model	CCR-81
Category	Desktop
Language	English