Radio Shack HTX-202 - Basic Operation; Resetting the Transceiver

USING THE TRANSCEIVER WITH PACKET RADIO
You can connect your transceiver directly to a packet radio terminal node con-
troller. See the following diagram for a suggested connection.
RESETTING THE TRANSCEIVER
When
you
first
use
the
transceiver,
if
the
transceiver
displays
ER1,
or
if
you
ever
want
to
reset
the
transceiver’s
options
to
the
factory
defaults
and
clear
ail
memories,
follow
these
steps.
Warning:
This
procedure
clears
all
stored
information
from
the
transceiver.
1.
Turn
off
the
transceiver.
2.
Press
and
hold
down
F+CLR.
Then,
turn
on
the
transceiver.
SAVE MSET MCLR MWR
(
Se
ee
SS
2
oes
VOLUME vsc aSC CLR
USING THE LIGHT
Press L on the side of the transceiver to turn to the display light for about 5 se-
conds. To turn off the light sooner, press L again. If you want the light to stay
turned on, press F+L at the same time. The fight stays on until you press L or
turn off the transceiver.
18