Radio Shack HTX-202 - ASIC CDCR ION Occa Esessiccnssnteuty Crasacoanananpevacveleidasauianscenidcavanevanvenslasassavesdivsyes; Setting Squelch and Volume; Cce Eee C Case Ssa Ee Reaesonaneesseseencenens; SPONUINHT: a PRGCUONGY: Hicks Cook Cat Ccecenseaicseepieniccdete te Acaesyeinh Meaievaceeeseeteea

BASIC OPERATION
rrr HG a eel
SETTING SQUELCH AND VOLUME
Rotate VOLUME clockwise and SQUELCH counterclockwise until you hear a hiss-
ing
sound.
Then,
slowly
rotate
SQUELCH
clockwise
until
the
noise
stops.
Leave
VOLUME set to a comfortable level.
If
the
transceiver
picks
upunwanted
weak
transmissions,
rotate
SQUELCH
clock-
wise
to
decrease
the
transceiver’s
sensitivity
to
signals.
SELECTING A FREQUENCY
You can use any of three methods to select a frequency to communicate on.
* Direct entry |
= Tune contro!
¢ Scanning for frequencies
Tuning Using Direct Entry
Your.transceiver transmits and receives
on frequencies between 144.000 and T-SQL DTMF +j— LOCK
148.000 MHz. To quickly tune to a fre- [2] [3 ]ca
quency, enter the frequency using the 0-SQL BEEP REV P.SC
keypad. _] EJ Ere]
1. Turn on the transceiver,
[e— Jur{c_}
2. Press VF. | oe V-SC M—VFO
3. Use the keypad to enter the fast four [+—] fo") [__)r [o__)
digits of the frequency. For example,
to enter 146.940, press 6940.
Notes:
¢ If you make a mistake, press CLR and repeat this step.
e The transceiver rounds the last digit down to 0 or 5.