GLOB
Parameter
Options Description
Battery Ni-MH,
Alkaline
or Ni-Cd
Loads low battery profile for
each different battery type.
Lo Batt Alert 0-60
seconds
Controls critical battery audible
alert. 0=off.
Battery Info SEL Displays current battery voltage,
DAC value and charge time
remaining if battery is charging.
Charge Time 0-99 Battery charge time in hours.
0=charger off. The battery char-
ger is timer based and charges
at a current rate of 150 mA. The
charger is disabled when BAT-
TERY is set to Alkaline. The de-
fault charge time (99) will charge
9 hours for Ni-Cd batteries and
16 hours for Ni-MH batteries.
Atten Mode Global or
Normal
The attenuator reduces the
amount of signal at the receiver
input. This helps reduce inter-
ference from strong nearby
transmitters. Global attenua-
tor mode applies attenuation
radio-wide, regardless of
individual object settings. In
Normal attenuator mode, the
attenuator follows the individual
object attenuator setting.
Global Atten On or Off When the Atten mode is set to
Global, this controls whether
the Global attenuator is on or
off.
Clear Hits SEL Press SEL to clear all
hit counters.
Hit Counts Yes or No Turns the hit counter feature on
or off.
GLOB
Parameter
Options Description
Dflt ScanList 0-22 Sets default destination Scan
Lists for new objects and
CONV Stor from Searches,
Signal Stalker II, and Tune. Use
1-20 for “normal” Scan Lists
1-20. Use 0 for the “ns” (not
scanned) Scan List (no Scan List
mappings are specified). Use 21
for the FAV Scan List. Use 22 for
the Skywarn Scan List.
Priority On or Off Turns Priority Scan On or
Off. Priority Scan can also be
toggled by pressing FUNC PRI
while scanning.
WxPri On or Off Toggles Weather Priority Mode
on or off. Also accessed by
pressing WX, then PRI.
Scan Lists SEL Enters sub menu for Scan List
settings and status.
SRCH L/Outs SEL Enters sub menu for review,
editing or deletion of search
lockout frequencies.
Clear FAV SEL Press SEL to clear the Favorites
Scan List.
Memory Info SEL Press SEL to see the current
memory usage.
EXPERT BELOW
Tune LED On or Off Activates Signal Strength driven
LED when in Tune mode.
Color 0-7 Red,
Green,
Blue
(RGB)
value
Sets intensity of red, green and
blue LEDs. Press SEL to edit
colors. Press _` to scroll to R, G
or B LED settings. Use numeric
keys to activate preset intensity
levels for each LED, or use ab
keys to fine scroll intensity.
Qtxt 1-0 Text
value
Sets QTXT (QuickText) 0-9 text.
Use “$” to indicate end of text.
Key Repeat On or Off Toggles key repeat mode when
a key is held down.
To Next Page
Loading...
