copying/moving a frequency
If you want to copy/move a frequency to a channel, follow the steps below:
1. Press ENT/PGM to put the scanner in programming mode. Enter the channel which
contains the frequency you want to copy or move.
2. Press MAN to advance the channel.
3. Press and hold ENT/PGM during program mode.
4. Select the bank where you want to copy or move the frequency.
5. Press ENT/PGM. The smallest empty channel number and “000.0000” appear. If there is
no empty channel, the scanner automatically selects the first channel of the bank.
6. Press ENT/PGM to enter the frequency, “Delete Source Channel?” appears.
7. To moving a frequency, press ENT/PGM. Or to copying a frequency, press CL.
searching for and temporarily storing active frequencies
If you do not have a reference to frequencies in your area, use a chain, fine tune, or service
search (except weather search) to find a transmission.
Beyond the Basics
Notes:
• While doing a chain, fine tune, or service bank search, press • /DELAY if you want to turn
the delay on or off (see “delay”).
• While doing a chain, fine tune, or service bank search, press FUNC, then MENU if you
want the scanner to skip data signals (such as fax or modem signals) and search only for
audio (voice) signals to enter the menu mode and turn Data Skip Option to off (see
“skipping data signals”).
chain search
This feature lets you search through preset frequency ranges. You can also preset a range.
There are three modes within this feature: chain search mode, chain search pause mode,
and program band select mode.
The preset frequency ranges are:
Bank No. Frequency (MHz) Step (kHz)
0 25.0000-27.9950 5
1 28.0000-54.0000 5
2 137.0000-174.0000 5
To Next Page
Loading...
