24
To skip a frequency, press
L/O/
SEARCH SKIP
when the scanner
stops on the frequency during a limit
or direct search.
To clear a single frequency from skip
memory so the scanner can stop on
it during a limit or direct search, press
LIMIT
to hold the search, press
D
or
—
to select the skipped frequency,
then press
L/O/SEARCH SKIP
until
LOCKOUT
disappears from the dis-
play.
To clear all the skip frequencies at
once, while in the search mode,
press and hold
L/O/SEARCH SKIP
un-
til the scanner beeps twice.
Notes:
• If you program more than 50
skip frequencies, each new fre-
quency replaces earlier ones,
starting from the first stored fre-
quency.
• You can select the skipped fre-
quency when the scanner is in
the hold mode. The scanner dis-
plays
LOCKOUT
when you
select a skipped frequency.
LISTENING TO
MONITOR MEMORIES
After you temporarily store frequen-
cies into the scanner’s monitor mem-
ories, you can listen to them by
pressing
MANUAL
,
MON
, then the
number for the monitor memory you
want to listen to.
Note:
To listen to the monitor memo-
ries, the priority channel feature must
be turned off (see “Designating a Pri-
ority Channel”).
20-414.fm Page 24 Wednesday, August 4, 1999 11:12 AM
To Next Page
Loading...
