30
To change the search speed, during
a limit or direct search, press
SPEED
to switch between the normal and
high speed search speeds. s or t
flashes on the display during high
speed search.
To select the hyper search speed,
during a limit or direct search, press
PRI/HYPER SEARCH.
SEARCH
flash-
es on the display during hyper search
speed.
Note:
You can use hyper search
speed only in 5 kHz-step bands.
DETECTING DATA
SIGNALS
You can set the scanner to detect
data signals (nonmodulated signals
such as preamble signals for pagers)
during a limit or direct search.
Note:
You cannot detect data signals
in the air band (AM mode).
To detect data signals, press
DATA
so
DATA
appears on the display. If
the scanner momentarily pauses on
a transmission and detects a data
signal, it resumes searching in 2 or 3
seconds.
To stop detecting data signals, press
DATA
so
DATA
disappears from the
display.
20-414.fm Page 30 Wednesday, August 4, 1999 11:12 AM
To Next Page
Loading...
